FURSE ESP Power SPD Single phase supplies with innovative remote display


Product Name：FURSE ESP Power SPD Single phase supplies with innovative remote display
Product Model：ESP 120 D1,ESP 240 D1,ESP 277 D1,ESP 208 D1 Series,ESP 415
Updated：2010.04.01
Views：2

Protection for single and three phase mains power supplies and power distribution systems 31

Combined Type 1, 2 and 3 tested protector (to BS EN 61643) for use on mains power distribution systems primarily to protect connected electronic equipment from transient overvoltages on the mains supply, e.g. computer, communications or control equipment. Innovative remote display options allow both protector and display to be mounted in their optimum position

Product part codes:
ESP 120 D1 Use to protect single phase mains power supplies of 90-150 volts
ESP 240 D1 Use to protect single phase mains power supplies of 200-280 volts
ESP 277 D1 Use to protect single phase mains power supplies of 232-350 volts
ESP 208 D1 Series Use to protect single phase mains power supplies of 156-260 volts
ESP 415 D1 Series Use to protect single phase mains power supplies of 346-484 volts
ESP 480 D1 Series Use to protect single phase mains power supplies of 402-600 volts

Very low let-through voltage (enhanced protection to BS EN 62305) between all sets of conductors (phase to neutral, phase to earth, neutral to earth - Full Mode protection)
Full mode design capable of handling partial lightning currents as well as allowing continual operation of protected equipment
Three phase ESP XXX D1R/LED or ESP XXX D1R/LCD units (where XXX = 208, or 415, or 480) have a remote display that allows the protector to be mounted close to the incoming feed or distribution board with the display being mounted in a visible position e.g. at the front of the panel
Three phase ESP XXX D1/LCD or ESP XXX D1R/LCD units have backlit LCD intelligent display offering clear status information that can be rotated should the unit be mounted on its side to facilitate short connection leads for optimal protection
Changeover active volt free contact enables the protector to be used to warn of phase loss (i.e. power failure, blown fuses etc)
Flashing warning of potentially fatal neutral to earth supply faults (due to incorrect earthing, wiring errors or unbalanced conditions)